Skip to content
Physical damp course
Rising damp

Physical Damp Course St George

A solid membrane cut into the base of the wall, one short section at a time.

Get a free quote

Takes a minute. A local damp specialist will call you back.

No obligation. Your details only go to one local damp specialist.

A physical damp course is a membrane built into the wall to cut it off from the wet ground below. It’s slower to install than an injected course, but it doesn’t depend on the wall absorbing anything evenly, so it works where injection can’t.

Where it’s needed in St George

Most St George homes are brick with sound mortar, and for those a damp course injection is usually the right fix. But some walls need a membrane:

Sandstone footings. Some of the older houses in Kogarah, Rockdale, Arncliffe, Bexley and Hurstville sit on footings of local sandstone. Stone absorbs cream unevenly, so an injected barrier ends up with gaps.

Soft early brick. Some Federation-era bricks are soft and porous, or have been damaged by years of salt. Cream can run straight through them rather than spreading along the joint.

Broken-down mortar. Where the mortar has crumbled, there’s no continuous joint to inject.

Failed injections. If a wall was injected years ago and is still damp, and the cause really is rising damp, a membrane is often the next step.

How we install it

The work goes in short runs. We cut or rake out a short length of the chosen joint, slide in a damp-proof membrane, and pack the slot solid with mortar. Only once that run is fully packed do we open the next, overlapping the membrane with the previous run so the barrier is continuous.

Because only a short section is open at any time, the wall above stays supported. That’s important under the heavy terracotta-tiled roofs common on St George bungalows.

Height is planned before cutting starts. The membrane must sit below the floor inside and above the ground outside. On the sloping blocks toward the Georges River, the course often has to step down along the wall.

On stone and very soft brick we repack with a lime-based mortar, which is softer and more breathable than cement and suits older masonry.

After the course goes in

The wall above the membrane is still holding water and salt. Stone and soft brick dry slowly. We remove the damaged plaster and apply a breathable salt-damaged plaster repair system that lets the wall keep drying through the surface.

If the outside ground or a path is sitting above the new course, it needs to come down, or water will bypass it. On blocks cut into the slope, waterproof tanking may be needed on walls with soil against them.

Older bayside homes

Brick homes on the low, sandy ground near Botany Bay have water close below them most of the year. Where those walls are built of soft brick or on stone, a membrane gives the most dependable barrier. Our guide on rising damp near Botany Bay explains why the area is prone to it.

Signs a membrane is the right call

You’ll often see it before we test: mortar that rakes out like sand, bricks with faces flaking away at the base, or a row of old filled drill holes along a wall that’s still damp. Each of those tells us injection is unlikely to hold, and the inspection confirms it.

The full picture

A membrane is often one part of a larger rising damp treatment that might also include subfloor airflow and drainage. Every part is listed in the written quote, wall by wall, before any work begins.

Updated

A membrane course takes longer than injection, so it costs more per metre. The price depends on wall material, thickness, length, access and the plaster to replace, all measured at the inspection.

What good physical damp course looks like

Close-up of physical damp course on a home in the St George area
What physical damp course looks like up close on a typical St George area home.
Signs that physical damp course needs attention
Typical signs that it needs attention.

Physical Damp Course in St George: step by step

  1. Mark the heightWe set the course below the inside floor and above the outside ground, stepping it where the block falls.
  2. Cut a short runA short length of joint is cut or raked out, leaving the rest of the wall supporting the load.
  3. Fit the membraneDamp-proof membrane is slid in and overlapped with the previous run.
  4. Pack and repeatThe slot is packed solid with compatible mortar before the next run is cut.

Physical Damp Course questions in St George

Something else on your mind? Call and ask.

When is a membrane better than injection?

When the wall can't hold injected cream evenly: sandstone footings, rubble bases, very soft or crumbling brick, or mortar so broken down there's no continuous joint. It's also the usual choice where injection has been tried and failed.

Is it safe for the house?

Yes. Only a short length of wall is open at any time, and each run is packed solid before the next is cut, so the wall above is always supported.

Does it take long?

Longer than injection, because the work is done in sections. The written quote gives an expected time on site for your house.

Damp walls in St George?

📞 Call now Free quote